Strength Minute Rounds 40/20 (10 Minutes)

Ready

00:00

Press start

10 minutes strength minute-rounds 40/20

Timer plan

{"version":1,"root":{"type":"sequence","items":[{"type":"loop","label":"Main set","repeat":10,"items":[{"type":"interval","label":"Lift","durationSeconds":40,"mode":"exercise"},{"type":"interval","label":"Rest","durationSeconds":20,"mode":"rest"}]}]}}

Edit timer

Workout Guidance

Plan notes

Intent summary

Use Strength Minute Rounds 40/20 (10 Minutes) as a planned strength session: 10 rounds, 40/20 work/recovery phases, and a short minute rounds total all point toward minute-based strength density with a built-in reset. That means adjust one load or variation variable at a time and keep the target repeatable for the intermediate version.

Work focus

In Strength Minute Rounds 40/20 (10 Minutes), each 40-second minute block should stay deliberate. For this strength timer, set up before the beep, brace first, and make every rep look the same. Finish a crisp target early enough to use the remaining time for setup. Because 40/20 is moderate inside a 10-minute minute rounds timer, settle into the target instead of surging at the start; watch setup quality, rep control, and consistent bracing before adding load, reps, or speed.

Rest summary

In Strength Minute Rounds 40/20 (10 Minutes), each 20-second recovery is short compared with the work. Use it for strength reset details in the 10-minute 40/20 plan: put equipment back in position, breathe down, and decide the next rep target before the clock starts; clear the previous rep and make the next start tidy. Across 10 rounds, the next minute rounds start should feel ready for the next minute with equipment and rep target already decided.

Pacing guidance

Start Strength Minute Rounds 40/20 (10 Minutes) with the final third of the strength session in mind. The 40/20 minute rounds pattern is work-heavy, which means the recoveries are limited, so repeatability matters more than peak output. Over 10 rounds, start controlled because there is not much time to recover from an early overshoot. Leave technical reps in reserve and avoid turning the first minutes into a max test.

Common mistakes

Choosing a rep target that fills the entire minute
Racing reps instead of keeping them clean
Choosing a load that forces rushed reps
Starting the next set before breathing settles

Safety notes

Use conservative loads and stop the set if form no longer matches the plan. Use movements and loads you can repeat cleanly. End the block early if setup, breathing, or form no longer stays controlled.

Related timers

Strength Minute Rounds 20/40 (10 Minutes)

Strength Minute Rounds 25/35 (10 Minutes)

Strength Minute Rounds 30/30 (10 Minutes)

Strength Minute Rounds 35/25 (10 Minutes)

Timer plan